Getting started with Kamikaze on Replicape Rev B

Finally a video that is specific to getting started with Replicape Rev B using the Kamikaze eMMC flasher!

There is a new Kamikaze image out that addresses some of the issues that have become apparent after people started to get their capes. To name a few:

If I access my printer on IP whatever, the OctoPrint link does not work.

The link is now gone. Instead, if you access your printer through your prowser you will be directed to OctoPrint directly.

How do I configure my printer?

The easiest way is to use OctoPrint for this. Upload the file you want to use through the redeem plugin interface in OctoPrint.

I can access OctoPrint, but I cannot connect!

When flashing your BeagleBone with Kamikaze, the flasher will check the signature of the EEPROM on the Replicape. If the signature is invalid, it will update it with the Replicape Rev B3 EEPROM file.

Something has gone wrong, where do I start to debug?

The log for Redeem is now placed in the “logs” section in OctoPrint, so that is a good place to start.

Once you are done with this video, go on to end stop configuration